New Boiler Cost UK 2026: Calculator, Prices and What Moves Them

Boiler Cost Calculator

How Much Does A New Boiler Cost?

Three questions and you get an indicative installed price band for a property like yours. It is a starting point for the conversation, not a quote.

By Lucas Morley, owner and heating engineer at Evo Flow Heating (Heat Geek partner, Gas Safe registered) · About Evo Flow Heating · Last updated 2026-08-11

Summary

Most homeowners asking how much does a new boiler cost get quoted a number before anyone has worked out what the house needs. The calculator above gives you an indicative installed band from three questions. The rest of this piece explains what actually moves that figure: the boiler is rarely the expensive part, and the gap between two quotes on the same house is usually sitting in the pipework, the cylinder and the controls rather than in the badge on the wall.

From Lucas, the owner

Ask any installer quoting you for the output figure in kilowatts and how they arrived at it. If the answer is a heat loss calculation for your building, you are talking to someone who has done the work. If the answer is bedroom count, or matching whatever came off the wall, you are being quoted a boiler rather than a heating system. That one question sorts most quotes into two piles before you compare a single price.

The honest answer to what a new boiler costs is that the appliance itself is the smallest part of the bill. A mid-range combi sits at roughly nine hundred to fourteen hundred pounds trade. When a quote comes back at three and a half thousand, the other two thousand is labour, pipework alterations, controls, a magnetic filter, a system clean, the gas safety work and the commissioning. That is where quotes on the same house diverge by a thousand pounds, and it is almost never because one installer is using a better badge.

So the number the calculator gives you is a starting point for a conversation, not a price. What follows is what sits behind it: how the output figure should be arrived at, where a low quote is usually finding its savings, and the situations where replacing the boiler is not actually the right spend.

New Boiler Cost UK: What Actually Moves The Price

Unvented hot water cylinder installed in an English airing cupboard with insulated pipework
Two bathrooms usually means a cylinder. It is the single biggest jump on the calculator and the most common reason two quotes differ.

Four things drive the figure, and only one of them is the appliance. The first is the output the property needs, which should come from a heat loss calculation rather than from bedroom count. The second is whether the boiler stays where it is. Moving it to another room means new gas, new flue, new condensate and new pipework, and that alone can add a thousand pounds to an otherwise straightforward job.

The third is hot water. A single bathroom with a combi is the simplest arrangement there is. Two bathrooms running at once is the point at which a combi starts to disappoint, and a system boiler with a properly sized cylinder becomes the sensible answer. That change is worth roughly eight hundred to fourteen hundred pounds, which is why the calculator jumps when you tell it about a second bathroom.

The fourth is the state of what is already there. Sound pipework and a clean system keep the job simple. Microbore that cannot carry the flow, a system full of magnetite, or a cylinder with an undersized coil all add work. None of that is visible from the doorstep, which is why an honest price follows a survey rather than a phone call. Our heating system design work exists precisely because that assessment is what makes the rest of the numbers real.

Thinking about a new system?

Talk to Lucas about a properly designed install

Free survey. Heat loss calculations before the quote, not afterwards. Written itemised quote with kit, labour and controls broken out. Gas Safe, MCS where the install is heat pump, and a Heat Geek-trained design head on every job.

Request a free survey →

Or call Lucas directly: 01474 612061

Combi Vs System Boiler: Which Do You Need?

Heating engineer going through an itemised boiler quote with a homeowner at a kitchen table
An itemised quote is the point at which you can compare two prices honestly.

A combi heats water on demand and needs no cylinder, which frees the airing cupboard and keeps the installation simple. It suits a one or two bathroom house comfortably. Its limit is simultaneous demand: run two showers and both drop off, because the boiler can only heat so much water per minute.

A system boiler works with a sealed cylinder and handles simultaneous demand properly. It costs more to install, takes cupboard space, and needs the cylinder sizing against how the household actually uses hot water rather than against the size of the house. Get the coil surface area wrong and the cylinder reheats slowly however good the boiler is.

A regular boiler, the traditional arrangement with a tank in the loft, is now mostly replaced rather than installed new. The exception is a property where the pipework and pressure make a sealed system awkward. If you are weighing the running costs of any of these against a heat pump, our air source heat pump page sets out where each genuinely makes sense.

How To Compare Boiler Quotes

A quote you can actually compare has the parts and the labour separated, the boiler model and output stated, and every extra listed as a line rather than folded into a single figure. If two quotes on the same house differ by a thousand pounds, the itemised one will show you exactly where.

Look for these specifically: the system clean or power flush, the magnetic filter, the controls being fitted, whether the gas supply is being upsized, and whether making good is included. A quote that omits the filter and the clean has not saved you anything, it has moved that cost into your first breakdown.

Ask what happens if something is found once the old boiler is off the wall. A fair answer is a stated hourly rate and a phone call before anything is done. A vague answer usually means a variation you find out about at invoice stage.

Verified Google review ★★★★★ 5/5

“New boiler installation. Lucas was very professional and obviously takes great pride in his work. He is friendly to deal with. He tidied up everything and even improved the installation by modifying the existing condensate pipework, so that most of it now runs inside the loft.”

Andy P. · Homeowner, Kent, new boiler installation (Google review)

What Size Boiler Do I Need?

The honest answer is that it comes from a heat loss calculation for your building, not from bedroom count and not from matching whatever came off the wall. Every room is measured, the construction and glazing accounted for, and the outputs added up. That total is the size of boiler the house needs.

It is almost always lower than people expect. Fitting whatever came off the wall requires no calculation, which is why so many British homes run boilers roughly double the output the building needs. An oversized boiler short cycles, firing and stopping repeatedly instead of running steadily, and that wears components faster and costs more to run. It is the one corner that never shows up on an invoice.

Sizing is not the only thing a low quote leaves out. The other three worth checking for are the system clean, which most manufacturers require in order to keep the warranty valid, the magnetic filter that protects the new heat exchanger, and the controls. A modulating boiler wired to a basic on-off control cannot modulate, so it runs hotter than it needs to every day it operates.

When To Replace A Boiler, And When Not To

Sometimes the boiler is not the problem. Radiators cold at the bottom, a house that never quite gets warm, or a boiler that keeps cutting out often point at a circuit full of debris rather than a failing appliance. A power flush and a filter can restore a system for a fraction of a replacement, and any installer who tells you that instead of selling you a boiler has just earned your trust.

A boiler under about ten years old with a repairable fault is usually worth repairing. Parts are available, and the economics rarely favour replacement until repairs start stacking up or the unit passes twelve to fifteen years. If you have had two significant repairs in eighteen months, that is the point the sums change.

And if you are on oil or storage heaters and the whole system needs work anyway, price a heat pump alongside the boiler before committing. When the pipework and emitters are being touched regardless, the gap between the two options narrows considerably. For a Kent-specific breakdown of installed costs by fuel and property type, our new boiler cost guide for Kent goes into the local figures in more detail.

  • Ask for the output in kilowatts and how it was arrived at. A heat loss figure for your building beats a bedroom count every time, and the answer tells you a great deal about who you are dealing with.
  • Check the quote itemises parts and labour separately rather than presenting one number. You cannot compare two prices that are not broken down.
  • Confirm the system clean and the magnetic filter are both included, not listed as optional extras further down the page.
  • Ask which controls are being fitted and whether the boiler will actually modulate with them. A modulating boiler on a basic on-off control cannot do what you paid for.
  • Establish what happens if something is found once the old unit is off the wall, and what it will cost. A stated rate and a phone call is the fair answer.
  • Check the registration. Gas Safe for gas, OFTEC for oil. Ask to see the card, and check the number on the register rather than taking the logo on the van at face value.
  • Get the warranty length in writing along with what keeps it valid, which is almost always an annual service on the anniversary of the install.

Related heating services and areas

Evo Flow Heating

Designed properly, not slapped on

Lucas designs the system and Lucas runs the install. Heat loss calc, flow rates, modulating controls and balanced commissioning on every job. Gas Safe registered, MCS-certified for heat pumps, and BUS grant claim handled for you. Itemised written quote with kit, labour, controls and VAT broken out, so three quotes can be compared like for like.

Request a free survey →

Or call Lucas on 01474 612061 · office 01474 612061

Frequently Asked Questions

How much is a new boiler in 2026?

For a straightforward gas combi swap in a three bedroom house, most installed prices land somewhere between 2,300 and 3,200 pounds. A four or five bedroom property with two bathrooms and a cylinder typically runs 3,600 to 5,200. Oil sits higher again. The calculator at the top of this page gives you a band for your own property, and a survey turns that into a fixed figure.

Why do boiler quotes vary so much for the same house?

Almost always because they include different work rather than different boilers. One may include a full system clean, a magnetic filter and modulating controls while another leaves all three out. Ask for both quotes itemised and the difference usually explains itself in about a minute.

Is it worth repairing an old boiler instead of replacing it?

Under about ten years old with an available part, usually yes. Past twelve to fifteen years, parts get scarce and repair bills start stacking up, and the sums change. Two significant repairs in eighteen months is the point most households are better off replacing.

Do I need a bigger boiler for a bigger house?

Not as often as people expect. Output should follow a heat loss calculation, not floor area, and a well insulated four bedroom house can need less output than a poorly insulated three bedroom one. Oversizing is the single most common fault we find, and it costs money every day the boiler runs.

Does a new boiler need a power flush?

The system needs cleaning to a standard the manufacturer accepts, and on an older system with visible debris that usually means a power flush. Fitting a new boiler onto a dirty circuit voids most warranties and shortens the life of the heat exchanger, so it is not a corner worth cutting.

Do you cover my part of Kent?

Yes. We work across Gravesend, Dartford, Maidstone, Tonbridge, Sevenoaks, Pembury and most of the county. Call 01474 612061 for a survey booking, or use the contact form and Lucas will ring you back.

Kent-based, covering the South East

Ready for a heating system that’s actually designed?

We work across Gravesend, Dartford, Maidstone, Tonbridge, Canterbury, Sevenoaks and the wider Kent area. Free survey, heat loss calculations and a written itemised quote. BUS grant claim handled for eligible heat pump installs.

Request a free survey →

Or call Lucas on 01474 612061 · office 01474 612061

For more Kent heating advice, browse the Evo Flow Heating blog or call Lucas on 01474 612061.

Related Articles